4/9/2023 0 Comments Polaris digital wrench crackTweak the handlebar position until both measurements are the same, then align the skis. Hop off the sled and measure with a tape from the left bar end to a fixed point on the left side of the sled, such as the rear suspension mount bolt. Sit on the sled, grab the bars and adjust them so they feel square. The first step of a ski alignment is to crack loose the jam nuts on the tie rods ends, then make sure the handle bars are straight. The consequence of this mistake is on par with the ancient Chinese water torture: it won’t cause any physical damage, but driving a sled down a trail with straight skis and crooked handlebars could drive a rider batty after a few miles. (Just make sure your riding buddies don’t catch you reading it.)Īn often forgotten step of ski alignment is to first set the handle bars straight. ![]() They’re not likely to admit they’ve made a mistake while wrenching on a sled, either, which might prevent them from knowing why their sled doesn’t track straight after aligning the skis or the drive belt slips after cleaning the clutches.įortunately this quiet, little magazine article sheds light on those private, embarrassing problems to help countless self-taught mechanics track down where they went wrong without anyone knowing the mistakes ever occurred. Most snowmobilers would rather chop off an arm with a hatchet than admit they don’t understand engine port timing or how a spring affects clutch shift rate.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |